![]() ![]() ![]() Your vinyl-lined pool wall will sit in between the flaps of the gasket. Step four: Connect the skimmer and vacuum gaskets to the pool wall You should be able to tell which hole you’ll need to use as it will be smaller than the rest. You can do this by screwing the port cover into the faceplate using the small hole on the bottom of the faceplate. Step three: Connect the vacuum port cover to the skimmer’s faceplate Be sure not to tighten the screws too much if your skimmer is made of plastic, as this can cause it to crack. Once the holes between the weir and skimmer are aligned, you can start screwing them together using either a drill (number 2 bit) or a screwdriver. Step two: Screw the weir and skimmer together Ensure that the three holes on the skimmer and the weir are aligned. Once you’ve found the weir, insert it through the top opening of the skimmer. Step one: Locate the weir and connect it to the skimmer The installation of pool skimmers for above ground pools differs from inground pools as there are no return jets to connect the skimmer to, and you will be cutting through the vinyl pool liner. Step nine: Turn the pool pump back onĮnsure that the water is flowing into the floating hat, the opening of the pool skimmer, so that debris can be caught in the bag or basket. This should clip in when appropriately aligned. The last step is to place the floating hat, the part that looks like a big O-ring, onto the top of the body. The pool skimmer should now be appropriately connected to the return jet and assembled correctly. Step eight: Put the floating hat on the body The opening of the outlet will be clearly marked. ![]() Step seven: Connect the clip-on bag or basketĭepending on your model, connect either the clip-on bag or basket to the outlet of the pool skimmer body. Once the elbow pipe has been fitted, use stainless steel screws to fasten and secure the connections. Once that is complete, connect the other end of the elbow to the union on the return jet. You will see a round opening for the pipe to be inserted into. Next, connect the elbow joint provided to the body of the pool skimmer. These connected parts are known as the union, the ring nut, the O-ring, and the fitting. Thread this fitting into the return jet, ensuring the ring nut and O-ring are tightly secured. These fittings are typically between 1 & ½ inches in size and are made from PVC. Step four: Install the fitting for the threaded return that your pool skimmer comes with ![]() Once you’ve done that, remove the O-ring from the jet. Sometimes, the ring nuts get stuck, so you might need some upper-body strength to unscrew them. Once you have located the return jet, you must carefully unscrew the ring nut and place the ring nut in a safe place outside the pool. Step three: Unscrew the ring nut and remove the O-ring These jets are usually located on your pool wall, where the water is released back into your pool. Pool skimmers cannot be installed when the pump is on. Inground Pools Skimmer Installation Step one: Turn off the pool pump I have outlined two sets of easy-to-follow installation instructions for you to follow, depending on your pool type. When it comes to pool skimmers, you have two options: one for above ground pools and one for inground pools. How to Install a Pool Skimmer: Step-By-Step
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |